Peak Pilates AFINA Owner's Manual And Assembly Manual page 25

Inspect
• Overall machine – We highly recommend that you visually inspect the machine
daily and that you thoroughly inspect all the hardware to make sure every nut,
bolt and fastener is secure every 2 months.
• Springs, Safety Chain and Clips – We strongly recommend that you inspect
all springs, safety chain and clips weekly. Severe nicks, abrasions or metal
fatigue may develop as a result of frequent use and could lead to premature
spring breakage. Not replacing springs in a timely manner increases the risk
of failure. While the breakage or deformation of a spring and the resulting
potential for serious injury is a remote possibility, periodic inspection of your
springs is critical. The springs are zinc- and nickel-plated to prevent rust
or corrosion from perspiration, condensation and humidity. Variation in the
brightness of the finish is the result of different plating batches and does not
affect the superb performance of our springs.
• Tracking System – The sealed bearings in the Carriage Wheels are
permanently lubricated and require no further lubrication. You should inspect
the Wheel Axles every 2 months.
Clean
• Framework – The wooden components on this equipment are finished with a
non-toxic, water-based lacquer. Other than an occasional wipe down using a
mild soapy solution and drying, no additional cleaning is necessary. The metal
framework should be cleaned with a mild soapy solution.
• Upholstery – We recommend wiping down your vinyl upholstery with a mild
cleaning solution such as ArmorAll® Multi-Purpose Cleaner diluted with water
in a 50/50 solution after each use.
• Tracking System – The tracks upon which your carriage rides are anodized to
inhibit the build-up of unsightly aluminum oxide residue. Clean them on an as-
needed basis using a warm, mild soapy water solution and dry thoroughly with
a soft cloth.
25
PEAK PILATES
®