Table of Contents
Advertisement
Tower Bracket Spacer Installation
Fig. 18
Fig. 19
Fig. 20
The final step for assembling the tower is
the installation of tower bracket spacers.
Please find the instructions for installing
these spacers below:
1. Take the tower bracket spacer
and place it inside the rail of the
reformer (Fig. 18).
2. Place the Allen key in the top hole of
the tower bracket spacer, the gently
lower the spacer into the tower
bracket (Fig. 19).
3. Insert the 45 mm screws with one
small washer per screw into the four
holes on the outside of the tower
bracket. Screw in the 45 mm screws
until they are finger tight.
Note: Use the Allen key to align the
holes while the tower bracket spacer
sits inside the tower bracket as
shown in Fig. 20.
4. Now tighten all 16 screws attaching
the tower to the reformer frame
with the Allen key until they are
completely tight and secure (Fig. 21).
Fig. 21
20
PEAK PILATES
®
Advertisement
Table of Contents
