Peak Pilates AFINA Owner's Manual And Assembly Manual page 21

Reinstalling the Push-Through Bar
Now that the tower is attached and secure to the reformer frame, you can now
reinstall the push-through bar onto the tower. To re-install the push-through bar,
please follow the instructions below (Note: these steps require at least two people):
1. Position the push-through bar at one of the three sets of holes in the tower.
2. Press the circular button at the top of the black handle to release the pins.
3. Insert the pins into the holes until they lock into place.
Fig. 22
Fig. 23
Wood trim
Tower caps
Fig. 24
Installing the Wood Trim
The Afina Reformer comes with four
wood pieces to cosmetically connect the
classical wooden frame with the modern
metal tower. The instructions for installing
this optional wooden trim is below:
1. Take the wooden blocks and remove
the protective covering from the
double-sided tape (Fig. 22).
2. Press the wooden blocks into the
tower extrusions (the lower right-
hand corner is shown Fig. 23).
The long wood blocks should be inserted
in the horizontal extrusions at the top of
the tower (on both sides). The short wood
pieces should be inserted in the lower
right- and left-hand corners of the tower
(only on the side that faces the reformer
frame).
Tower Cap Installation
The tower also comes with four circular
plastic tower caps that protect the metal
frame when it is un-installed from the
reformer and resting against other
surfaces like the floor. Simply insert the
caps into the four holes on both sides of
the top two corners of the tower. Two
installation points are shown in Fig. 24.
21
PEAK PILATES
®