Jumper Settings; At/Atx Power Mode Select Jumper; Table 4-1: Jumpers - IEI Technology PICOe-HM650 User Manual

4.4 Jumper Settings

NOTE:
A jumper is a metal bridge used to close
an electrical circuit. It consists of two or
three metal pins and a small metal clip
(often protected by a plastic cover) that
slides over the pins to connect them. To
CLOSE/SHORT
connecting the pins of the jumper with
the plastic clip and to OPEN a jumper means removing the plastic clip
from a jumper.
Before the PICOe-HM650 is installed in the system, the jumpers must be set in
accordance with the desired configuration. The jumpers on the PICOe-HM650 are listed in
T able 4-1.
7
Description
AT/ATX power mode select
Clear CMOS
LVDS voltage select
LVDS panel resolution select
PCIe status select
TPM setting
Flash descriptor security override

Table 4-1: Jumpers

4.4.1 AT/ATX Power Mode Select Jumper

Jumper Label:
Jumper Type:
Page 54
PICOe-HM650 Half-size PCIe CPU Card
a jumper means
Label
J_ATXCTL1
J_CMOS1
J_VLVDS1
J_PID1
J_PCIE1
ME_RTC1
J_FLASH1
J_ATXCTL1
3-pin header
Type
3-pin header
3-pin header
3-pin header
8-pin header
2-pin header
3-pin header
3-pin header