Yunca Gas LEEDZ Operations, Maintenance & Warranty Information page 13

CLEANING THE TOP AND LOUVRES
The top panel is held in place by four retaining clips, two on the back panel and one on
each side. The top panel should only be removed with the side panels closed.
Note: If a flue guard kit has been fitted this will need to be removed at this stage. This is
done by sliding the front half up and out and unscrewing the back half from its brackets.
The top panel can be lifted up off the retaining clips, this will take a moderately strong
pull.
Slide the top panel up the flue until there is sufficient space to vacuum any dust and lint
that may be lying under the panel.
This is also a good time to wipe the front louvers with a soft cloth.
INSPECTING THE VENTING
An inspection of the venting system should be made during the annual service
appointment. There must be no blockages and the flue must be in good repair. Any
sections that are taken apart for inspection must be reassembled and sealed as
required.
CLEANING THE FAN FILTER
This is the one maintenance procedure designed to be carried out by the householder.
It can be cleaned with a brush or vacuum cleaner, and replaced.
25-07-01 Page 13 of 22 Operation Instructions for Leedz Free Standing July 2001.doc