Yunca Gas LEEDZ Operations, Maintenance & Warranty Information page 10

Allow both burners to run for 30 minutes to bring the room up to temperature.
9. Turn the back burner off.
10. Adjust the thermostat down, to the front burner turns off. Note the thermostat
number and turn up by ½ to1 ½ a thermostat number till the front burner turns on.
11. Leave the fan on. Note Fan can be turned off, Higher efficiency is achieved with
the fan running
To further increase the room temperature follow the following steps:
st
1 Turn the fan on to high speed.
nd
2 Turn the thermostat up one number.
rd
3 Turn the secondary burner on to minimum.
th
4 turn the secondary burner up to maximum.
Note: Various combinations of the settings of knobs "B" and "C" will provide different
heat settings and flame effects.
The first few times that the heater is lit it should only be running for about twenty
minutes. And then allowed to cool. This will eliminate damage to paints and
reduce the smoke and odour caused by burning off of manufacturing oils etc.
HOW TO TURN OFF THE HEATER.
1. If the thermostat, knob "B", has been in use turn it to its lowest position.
2. Turn the rear burner control, knob "C", to the off position.
3. Turn off the electrical power at the wall.
4. Push in the pilot control knob "A" and turn it clockwise to off.
Note: the knob cannot be turned from "pilot" to "off" unless it is pushed in slightly.
Do not force it.
25-07-01 Page 10 of 22 Operation Instructions for Leedz Free Standing July 2001.doc