Yunca Gas LEEDZ Operations, Maintenance & Warranty Information page 14

HOW TO REMOVE FAN
The fan unit is designed to be removed as an assembly.
The procedure for this is as follows.
1. Turn off and unplug power to unit.
2. Take out four screws that attach the fan-mounting bracket to the base.
3. Reach inside the plinth and disconnect the wiring from the switch, taking note of
terminal placement. A wiring diagram appears at the back of this manual.
4. The earth wire must be unplugged and the plastic conduit adapter removed from its
retaining bracket.
5. The fan unit will now slide out of the back of the heater.
6. When the fan has been removed it can be disassembled as shown below if needed.
25-07-01 Page 14 of 22 Operation Instructions for Leedz Free Standing July 2001.doc