Maintenance - Yunca Gas LEEDZ Operations, Maintenance & Warranty Information

MAINTENANCE

A qualified service person recommended by your YUNCA dealer should conduct an
annual inspection and undertake any maintenance required on your LEEDZ. Its venting
and installation must be checked to keep it running safely and efficiently. The following
procedures should be performed only by a qualified service person. The gas supply and
electrical power should be isolated whenever any maintenance procedures are
undertaken.
Note: the door can only be removed after the heater has been turned off for long
enough so that the door has cooled to touching temperature.
Removing The Front Door
1. First the side panels must be removed, to do this grip panel at its base and pull out.
The panel should be swung out to about 30 degrees and then pulled down to release
the locating pins in its top.
2. This will expose the restraining latches at each side. To open these latches lift the
butterfly grip forward and twist it through 180 degrees.
3. The front door can now be removed by griping it by its back bottom corners and
pulling it straight back and out.
Note: It is important not to spread the sides out any further than is necessary to
remove door, as this may damage the doors enamel coating
Removing The Glass For Replacement.
1. Remove the front door as described above, and place front down on a soft surface.
2. Remove the two side glass retainers by taking out the three bolts in each one.
3. Remove the bottom front glass retainer by taking out the four screws along the base
of the door.
4. To remove the front glass place one hand under it and lift it up and out of the
doorframe.
5. Remove the side glasses
6. New glass with gasket attached can be ordered through your YUNCA LEEDZ agent.
Note: Only recommended heat resistant glass may be fitted.
7. Place replacement glass in position in the reverse order of removal, i.e. Side glass
should be placed in position before front glass.
8. Replace side and bottom glass retainers with their respective bolts and screws.
Note: Tighten the screws and bolts alternately, do not over tighten to avoid damaging
glass.
25-07-01 Page 11 of 22 Operation Instructions for Leedz Free Standing July 2001.doc