CLEARANCES
The YUNCA LEEDZ FLUED GAS HEATER should be installed with clearances equal to
or greater than those recommended below and comply with NZS 5261/ AG601.
This is to ensure adequate air circulation around the heater and avoid heat damage to
wall coverings.
Note: If walled surface is incombustible i.e. brick or steel, side clearances may be
reduced by 100mm, and the back clearance to a minimum of 75mm. Corner positions
remain the same.
(See Fig. 3 Below)
(Fig. 3)
25-07-01
Page 6 of 22
Operation Instructions for Leedz Free Standing July 2001.doc