Maintenance/Cleaning - Yunca Gas LEEDZ INBUILT Operations, Maintenance & Warranty Information

10. Turn the back burner off.
11. Adjust the thermostat down, until the front burner turns off. Note the thermostat number and turn
up by ½ to 1½ a thermostat number till the front burner turns on.
12. Leave the fan on.
To further increase the room temperature follow the following steps:
st
1 Turn the fan on to high speed.
nd
2 Turn the thermostat up one number.
rd
3 Turn the secondary burner on to minimum.
th
4 Turn the secondary burner up to half on.
th
5 Turn the secondary burner up to maximum.
Note: Various combinations of the settings of knobs "B" and "C" will provide different heat settings
and flame effects.
The first few times that the heater is lit it should only be running for about twenty minutes. And
then allowed to cool. This will eliminate damage to paints and reduce the smoke and odour
caused by burning off of manufacturing oils etc.
HOW TO TURN OFF THE HEATER.
1. Turn the rear burner control, knob "C", to the off position.
2. Turn off the fan and then electrical power at the wall.
3. Push in the pilot control knob "A" and turn it clockwise to off position.
Note: the knob cannot be turned from "pilot" to "off" unless it is pushed in slightly.
Do not force it.
MAINTENANCE
A qualified service person recommended by your YUNCA dealer should conduct an annual inspection
and undertake any maintenance required on your LEEDZ. Its venting and installation must be checked
to keep it running safely and efficiently. The following procedures should be performed only by a
qualified service person. The gas supply and electrical power should be isolated whenever any
maintenance procedures are undertaken.
Note: the front glass can only be removed after the heater has been turned off for long enough
that the door has cooled to touching temperature.
09-06-01 Page 10 of 10 op-instruct-leedz-ib.doc