Table of Contents
Advertisement
MAINTENANCE.
A qualified service person should conduct an annual inspection and undertake any
maintenance required on your entis heater. The venting and installation must be checked to
keep it running safely and efficiently. The gas supply and electrical power should be isolated
whenever any maintenance procedures are undertaken.
Note: The glass door can only be removed after the heater has been turned off for long
enough so that the door has cooled to a safe temperature.
Before attempting the following maintenance procedures, be sure to follow instructions on page
5 to avoid damage to your fire.
REPLACING THE GLASS
1. Remove the front door as described previously, and place front down on a soft surface.
2. Remove the four screws holding the glass retainer.
3. The glass and old thermotape seal can be lifted clear and discarded.
4. New glass (1610EIB) and thermotape seal (1611EE) can be ordered through your YUNCA
agent.
Note: Only recommended heat resistant glass may be fitted.
5. Place replacement glass in position in the reverse order of removal.
Note: Tighten the screws alternately, do not over tighten to avoid damaging glass.
Screws and spire clips may need replacing if suitable assembly compression cannot
be achieved.
CLEANING THE GLASS
The glass may be cleaned with damp paper towels. Ceramic glass cook top cleaner may also
be used. The inside of the glass may also need cleaning from time to time (refer page 5 for
glass door removal information).
Note: Never clean the glass when it is hot. Do not use abrasive cleaners on the glass.
CLEANING THE CHASSIS
The enamelled chassis may need cleaning from time to time to remove a white film (refer page
5 for glass door removal information). The chassis is enamelled so a wipe over with a damp
cloth when the chassis is cool will be sufficient.
REPLACING THE DOOR ROPE (GASKET)
The YUNCA entis has a 10mm fibreglass gasket (part number 1608EE) surrounding the front
glass door. Should it ever need replacement, use only the replacement gasket that is available
from your YUNCA dealer.
Procedure:
1. Remove the glass door as described on page 5.
2. Unscrew the bottom glass retainer.
3. Remove the existing gasket.
4. Fit new gasket ensuring the gasket is not stretched.
5. Replace the glass retainer.
6. Replace the door.
Revised 22-08-07
Yunca entis instal Aug07
.
Page 16 of 23
Advertisement
Table of Contents
