Brake Fluid - Can-Am Spyder RT Series Instructions Manual

rmo2014-005-010_a
TYPICAL
1. Coolant reservoir cap
8. If required, add recommended coolant until it
is visible in the reservoir, slightly above COLD
level mark. Use a funnel to avoid spillage. Do
not overfill.
9. Reinstall the service cover.

Brake Fluid

WARNING
Avoid contact of brake fluid with skin or eyes
because it may cause severe burns. In case
of contact with the skin, wash thoroughly. In
case of contact with the eyes, immediately
rinse with plenty of water for at least 10 min-
utes and then consult a doctor immediately.
NOTICE
Do not overfill brake fluid reservoir.
Recommended Fluid
Use only DOT 4 brake fluid from a sealed con-
tainer. An opened container may be contaminated
or may have absorbed moisture from the air.
NOTICE To avoid serious damage to the brak-
ing system, do not use non-recommended flu-
ids. Brake fluid can damage plastic and painted
surface. Handle with care.
PREDELIVERY
Brake Fluid Level Verification
Clean filler cap before removing. Use only
DOT 4 brake fluid from a sealed container.
1. Park the vehicle on a firm, level surface.
2. Unlatch and lift the seat.
3. Check the brake fluid level in both reservoirs,
near the back of the seat. They should both be
above the MIN. mark.
rmo2010-001-013_b
TYPICAL
1. Brake fluid reservoir
4. Clean the filler caps before removing.
5. Add recommended fluid as required. Do not
overfill.
rmo2010-001-091_a
1. Brake fluid MAX. level mark
2. Brake fluid MIN. level mark
2014-1
FLUIDS
WARNING
39 / 52