Shutting Down (Standby Mode); Resume Function; Setting The Date/Time; Inserting And Removing Sd Cards - Tascam dr-44wl Reference Manual

3 – Preparation

Shutting down (standby mode)

When the unit is turned on, slide the HOLD/
left side panel in the direction, and when the
-
DR 44WL shutting down
The power turns off after the unit completes its shutdown
process.
CAUTION
Always use the HOLD/
Do not remove the batteries or disconnect the power cable
(AC adapter GPE053B included with the unit or USB cable)
accidentally while the unit is operating. If you do so, the unit
cannot shut down properly and all recordings, settings and
other data will be lost. Any lost data and/or settings cannot
be restored.

Resume function

The DR-44WL is equipped with a resume function to locate the
previous position (or time) when the power was turned off.
Turn the power on and press the 7/9 button to play back
from the previous file position (time) when the power was
turned off.
NOTE
The position is recorded in the SD card. The resume function
does not work if the SD card is replaced or formatted.

Setting the date/time

The DR-44WL uses its internal clock to record the date and time
to the recorded files.
1. Press the MENU button to open the
2. Using the wheel, select (highlight)
and press the ENTER/MARK or / button.
The screen is displayed.
SYSTEM
3. Use the wheel to select
DATE/TIME
ENTER/MARK or / button.
appears selected for the
Exec
4. Press the ENTER/MARK button to open the
screen.
TIME
14
TASCAM DR-44WL
switch of the
TASCAM
appears, release the switch.
switch to turn the power off.
screen.
MENU
menu item
SYSTEM
and press the
item.
DATE/TIME
DATE/
5. Press the . button or / button to move the cursor
(highlighted area), and use the wheel to change values.
6. Press the ENTER/MARK button to confirm the change and
return to the screen.
SYSTEM
NOTE
The file name will include the set date/time. (See "Setting
the file name type" on page 56.)
CAUTION
The date and time setting can only be maintained for a few
minutes if the battery power becomes low or the unit is not
powered by the dedicated AC adapter (GPE053B) included
with the unit or USB cable.
When using batteries, we recommend to replace them
before they are completely drained.

Inserting and removing SD cards

Inserting the SD card

NOTE
When the product is purchased, the SD card slot has an SD
card already installed. If you want to use this SD card to
record and play tracks, there is no need to reinstall it.
1. Open the SD card slot cover on the left side panel.
2. Insert the SD card into the slot as shown in the following
illustration until it clicks into place.

Removing the card

1. Open the SD card slot cover.
2. Press the SD card in gently and then release it to allow it to
come out.