Power and display settings (POWER/
DISPLAY)
Use the
POWER/DISPLAY
display of the unit.
Follow the below steps to display the
screen:
1. Press the MENU button to open the
2. Using the wheel, select (highlight)
and press the ENTER/MARK or / button.
The
POWER/DISPLAY
3. Use . button and / button, ENTER/MARK button
and wheel to make settings for different items.
The following settings for each item can be made in the
screen.
POWER/DISPLAY
Auto power save function setting
Use the
AUTO PWR SAVE
turn-off (standby mode), counting from the last operation.
Options:
(no automatic turn-off ),
OFF
,
10 min
30 min
Battery type settings
Use the
BATTERY TYPE
This setting is used to display the remaining battery power and
to calculate the minimum capacity for normal operation.
Options:
(alkaline batteries, default value),
ALKAL
(nickel-metal hydride batteries)
Ni-MH
Set the voltage value of the phantom power
supply
Use the
PHANTOM VOLT
the phantom power supply to connect an external microphone
that requires phantom power.
Options:
,
(default value)
+24 V
+48 V
NOTE
Battery power will be consumed faster when set to
than when set to
.
+24V
screen to set the power and
POWER/DISPLAY
screen.
MENU
POWER/DISPLAY
screen will appear.
item to set the time for automatic
,
,
3 min
5 min
(default value)
item to set the battery type.
item to set the voltage value of
+48V
13 – Settings and Information
Backlight setting
Use the
item to set the time for automatic
BACKLIGHT
turn-off of back-light in battery operation, counting from the
last operation.
Options:
(turned off ),
OFF
,
10 sec
15 sec
turned on)
Adjusting the display contrast
Use the
item to adjust the display contrast.
CONTRAST
Options:
-
(default value:
1
20
Set the peak hold
Use the
item to set the peak display of the level
PEAK HOLD
meter.
Options:
,
OFF
1 sec
(default value),
5 sec
,
,
(always
30 sec
ALWAYS
)
8
(default value),
HOLD
57
TASCAM DR-44WL