Recording Screen - Tascam dr-44wl Reference Manual

Icon On/off status
Blank Key control function off
Key control function on
Key control function on (setting disabled
state)
Reverb on/off status display
3
This icon shows the reverb on/off status.
Icon On/off status
Blank Reverb is off
Reverb is on (sound effects recording) INT
MIC, EXT IN
Reverb is on (SEND status) MIX
Speaker output display
4
displayed: Speaker output on
Blank: Speaker output off
Phantom power supply display
5
Blank: No phantom power supply
: 48V phantom power supplied
: 24V phantom power supplied
Power supply status message
6
When power is supplied from the batteries, the current
battery level is displayed in bars (
When the battery level is low, the
will be switched off (standby mode).
When the dedicated AC adapter (GPE053B) supplied with
the product or USB bus power is used,
NOTE
When attempting recording or other operations that
consume large amount of power, a warning message of
may pop-up.
Battery Low
Recorder status message
7
The recording status is indicated in the following icons:
Indicator Detail
Stop
8
Pause
9
Playback
7
Fast-forwarding
,
Fast-rewinding
m
Skip forward to the beginning of the next
/
file
Skip backward to the beginning of either the
.
current or preceding file
Loop playback setting status display
8
During loop playback, the
Filename/song name display
9
When the 4CH mode is selected, the name or tag infor-
mation of a file being played back is shown.
The ID3 tag information is displayed instead when included
in the MP3 file.
When there are multiple files in the 4CH mode, only the
format portion of each of the file names and the basic
number of a recording file are displayed. When a single file is
recorded, its name is shown.
When the MTR mode is selected, the name of an opened
song is shown.
2 – Names and functions of parts
, , ).
will flash and the power
appears.
icon is displayed.
NOTE
ID3 tag information contains titles and artist names, which
can be stored in MP3 files.
Loop playback IN (starting) and OUT (ending) points
0
setting status
The IN (starting) and OUT (ending) points-setting state of
the loop playback is shown.
When the IN (starting) point is set, the
set position on the playback position-displaying bar.
The icon appears at the playback position on the bar
when the OUT (ending) point is set.
Playback position display
q
The current playback position is shown by a bar. As playback
progresses, the bar extends to the right.
Level meter guide display
w
This is a level meter guide for adjusting the input and output
levels. It is displayed at the "−12 dB" position of the scale.
Level meter
e
This meter displays the level of an input sound or that of a
playback sound.
File status display
r
The file state is displayed in different ways, depending on
the type of a file to be played back.
: Stereo file status
: Status of two mono files
: No file
Elapsed time display
t
Displays the elapsed time (hours: minutes: seconds) of the
current file.
Remaining time display
y
Displays the remaining time (hours: minutes: seconds) of the
current file.
Peak value displayed in decibel (dB)
u
Displays the maximum playback level in decibel reading per
set amount of time.

Recording Screen

The following recording screen is displayed in recording or
recording standby mode.
Recording screen in the 4 CH mode
icon appears at the
9
TASCAM DR-44WL