Shutting Down - Tascam DR-40 Reference Manual

3 – Preparation
CAUTION
When the unit is started up for the first time (or when
the built-in clock is reset after being left unused without
batteries), the DATE/TIME screen appears before the start-up
screen to adjust the date and time. (See "Setting the date and
time" on page 29.)
Press the . or / button to move the cursor (highlighted
area), and use the + or – button to change values.
Press the ENTER/MARK button to fix the settings.
The start-up screen is displayed, and then the Home Screen
appears after the unit has started up.
Date/time adjustment may be skipped by pressing the
ENTER/MARK button, and made later. (See "Setting the date
and time" on page 29.)

Shutting down

Press and hold the (HOME) [8] button until LINEAR PCM
RECORDER appears on the display.
The power turns off after the unit completes its shutdown
process.
28
TASCAM DR-40
CAUTION
(HOME) [8] button to shutdown the
Always use the
unit.
Do not remove the batteries or disconnect the power cable
(AC adaptor TASCAM PS-P520E or USB cable) accidently while
the unit is operating. If you do so, the unit cannot shut down
properly and all recordings, settings and other data will be
lost. Lost data cannot be restored.
Resume function
The unit has resume function. When started up, the unit is
located to the position (time) where it left off when shut down
previously.
If the PLAY [7] button is pressed after start-up, the file the
unit was playing when shut down previously starts to be
played from the position (time) where the unit left off when
shut down.
NOTE
The required data are stored in the SD card. The resume
function does not work if the card is exchanged or formatted.