14 - Messages - Tascam dr-44wl Reference Manual

14 – Messages
The following is a list of pop-up messages.
DR-44WL displays pop-up messages according to situations.
Refer to this list when you want to know the meaning of each
message and a method of dealing with a problem.
Message Details and solutions
The batteries are empty.
Battery Empty
Replace the batteries.
The selected division point is not appro-
Can't Divide priate for DIVIDE action. (Beginning of a
file, end of a file)
The SD card cannot be recognized
Card Error
properly. Replace the card.
The SD card has no remaining capacity.
Card Full Erase unnecessary files or transfer them to
a computer.
Current File MP3 MP3 files cannot be divided.
The name of the DIVIDE file to be created
is identical to the name of the file that
already exists in the same folder. The
Dup File Name DIVIDE function adds "_a" or "_b" to the
end of the file name. Before using the
DIVIDE function, connect the DR-44WL to a
computer and edit the file name.
The total number of folders and files
exceeded the limit (5000). Delete unnec-
File Full
essary folders and files or move them to a
computer.
The DIVIDE function would cause the file
name to exceed 200 characters. The DIVIDE
function adds "_a" or "_b" to the end of
File Name ERR the file name. Before choosing the DIVIDE
function, connect the unit to a computer
and edit the file name to less than 198
characters.
The file cannot be found or damaged.
File Not Found
Check the target file.
System files required to operate the
File Not Found DR-44WL is missing. When this message
Make Sys File appears, press the ENTER/MARK button to
automatically create a system file.
File Protected The file is read only and cannot be erased.
The SD card is not formatted properly or
the card may be broken. This message
also appears when a computer under USB
connection formatted the card, or when an
unformatted card is inserted to the unit.
Format Error Always use the DR-44WL to format cards to
Format CARD be used with it. Replace the SD card with
another or press the
ENTER/MARK button while this message is
being shown to format the card.
Formatting will erase all the data on the
SD card.
Invalid Card
The SD card may be abnormal. Replace the
SD card.
Change Card
The system file required to operate this
Invalid SysFile
unit is invalid. When this message is being
displayed, press the ENTER/MARK button
Make Sys File
to create a new system file.
The IN (start) and OUT (end) points are
I/O Too Short too close. Re-set by spacing at least one
second in between.
58
TASCAM DR-44WL
Message Details and solutions
Folders can be created only up to two
Layer too Deep layers. You cannot create a new folder
inside this folder.
The battery charge is low, so Wi-Fi cannot
Low battery,
be used. Replace the batteries with new
Wi-Fi OFF
ones.
Max File Size The file is larger than the designated size.
The SD card is not formatted properly or
the card may be broken. Replace the SD
card with another or press the ENTER/
MBR Error Init
MARK button while this message is being
CARD
shown to format the card.
Formatting will erase all the data on the
SD card.
A SD card is not set. Insert a recordable SD
No Card
card.
There are no files available for playback.
No PB File
The file may be damaged.
The file type is not supported. Please see
Non-Supported "11 - Connecting with a Computer" for file
formats that this unit can use.
Switched To The power supply has changed from the
Internal Battery USB buss power to the internal batteries.
Writing to the SD card was not in time.
Write Timeout
Back up files to a computer and format the
card.
Can't Save Data
Device Error
File Error
Not Continued
Player Error
Remote Cmd
Restart the unit when this error message
Remote Rx
appears.
Writing Failed
If the power cannot be turned off, remove
the batteries, disconnect the dedicated AC
Sys Rom Err
adapter (GPE053B) provided with the unit,
System Err 50
or disconnect the USB cable when in bus
System Error 1
power supply.
If these error messages appear frequently,
System Error 2
please contact the TEAC Repair Center (see
System Error 3
the back cover for contact details).
System Error 4
System Error 5
System Error 6
System Error 7
System Error 8
System Error 9