Adjusting The Size Of The Sewing Area - Pfaff 3108-1/1306 Instruction Manual

9

Adjusting the size of the sewing area

.07
Fig. 9 - 07
A comparison between the sewing area size entered and the actual sewing area size of the
work clamp ensures that seam programs, which are not within the sewing area size, cannot
be sewn.
● Measure the sewing area size of work clamp 1.
● With the machine in its basic position, select the input mode. (LED is illuminated).
● Call up parameters "201 - 204" in sequence by pressing the relevant +/- button.
● Enter the access code if available - see chapter 11.04.01 Input access code.
● Enter the measured value via the relevant parameter (in 1/10 mm)
Parameter
● Finish the parameter input and switch to sewing mode (home position of the machine).
1
If the actual and the entered sewing area size do not concur with each other,
severe damage can be caused to the machine!
NO
201
201 = Min. X-Coordinate (-650 bis 0)
202 = Max. X-Coordinate (0 bis 650)
203 = Min. C-Koordinate (-1000 bis 0)
204 = Max. C-Koordinate (-1000 bis 0)
VAL
-650
Setting up
31