Table of Contents
Advertisement
8
Switching the machine on/off
.04
Fig. 8 - 04
● Check air pressure on pressure gauge 1 and, if necessary, adjust air pressure with
adjusting knob 2.
● Turn main switch 3 to position "I"
HOME
MOVE CARRIAGE
● The machine will drive into home position after the controls have been booted.
In programs with obstacles, the prompt "HOME MOVE CARRIAGESDSq, and the clamp
will have to be moved to the home position by hand (= needle in the rear left corner of
the clamp).
● After shifting the clamp manually, press the "Basic position" button.
● Carry out a test run, see Chapter 10 Sewing.
● To switch off the machine, turn main switch 3 to position "0".
Mounting and commissioning the machine
1
At fi rst commissioning of the machine, the zero points and
the potentiometer for motor speed reduction must be checked and set
(see chapter 8.05 and 8.06 ).
2
3
Fig. 8 - 05
HOME
PUSH HOME KEY
21
Advertisement
Table of Contents
