Safety; Directives; General Notes On Safety - Pfaff 3108-1/1306 Instruction Manual

Safety

1 Safety
1

Directives

.01
This machine was built in accordance with the European regulations stated in the Conformi-
ty and Manufacturer's Declaration.
In addition to this Instruction Manual, also observe all generally accepted, statutory and oth-
er regulations and legal requirements - also those of the country in which the machine will
be operated - and all valid environmental protection regulations!
Applicable local regulations of the social insurance society for occupational accidents or oth-
er supervisory organizations are to be strictly adhered to!
1

General notes on safety

.02
● This machine must only be operated by adequately trained operators and only after hav-
● All Notes on Safety and Instruction Manuals of the motor manufacturer are to be read be-
● The Danger and Safety Instructions on the machine itself are to be followed!
● This machine must only be used for the purpose for which it is intended and must not be
● When leaving the machine unattended and during maintenance work, the machine must
● Daily maintenance work must only be carried out by appropriately trained personnel!
● When carrying out servicing or repair work on pneumatic devices, the machine must be
● Repair work and special maintenance work must only be carried out by specialists or ap-
● Work on electrical equipment must only be carried out by appropriately trained specialist
● Work is not permitted on parts and equipment which are connected to the power supply!
● Modifi cations and alterations to the machine must only be carried out pursuant to all rele-
● Only spare parts which have been approved by us are to be used for repairs! We express-
6
ing completely read and understood the Instruction Manual!
fore operating the machine!
operated without its safety devices. All applicable safety regulations must be observed.
be disconnected from the power supply by operating the main switch or by removing the
plug from the mains!
disconnected from the pneumatic supply network! The only exceptions to this are adjust-
ment work and functional tests carried out by appropriately trained personnel!
propriately trained personnel!
personnel!
Exceptions to this are contained in the regulations EN 50110.
vant safety regulations!
ly point out that any replacement parts or accessories not supplied by us have not been
tested and approved by us. The installation and/or use of any such products may result in
negative changes to the constructional characteristics of the machine. We are not liable
for any damage which may be caused by non-original parts.