Setting up
9
Adjusting the size of the sewing area
.07
●
●
●
●
●
●
●
32
1
X
Y
Fig. 9 - 06
With the machine in its basic position, select the input mode. (LED is illuminated).
With the corresponding +/- key select parameter "023".
If required, enter the access code, see Chapter 11.05.01 Entering the access code.
With the corresponding +/- key enter the measured value (in 1/10 mm) for the
X-axis.
With the corresponding +/- key select parameter "024".
With the corresponding +/- key enter the measured value (in 1/10 mm) for the
Y-axis.
Conclude the input by pressing the TE key. (Machine changes to the sewing mode).
A comparison between the sewing area size
entered and the actual sewing area size of
the button clamp ensures that seam pro-
grams, which are not within the sewing area
size, cannot be sewn.
●
No
VAL
023
-23
23
If the actual and the entered se-
wing area size do not concur
with each other, severe damage
can be caused to the machine!
Measure the sewing area size of button
clamp 1.