Adjustment; Notes On Adjustment; Tools, Gauges And Other Accessories For Adjusting; Abbreviations - Pfaff 3108-1/1306 Instruction Manual

Adjustment

13 Adjustment
13

Notes on adjustment

.01
All following adjustments are based on a fully assembled machine and may only be carried
out by expert staff trained for this purpose.
Machine covers, which have to be removed and replaced to carry out checks and adjust-
ments, are not mentioned in the text.
The order of the following chapters corresponds to the most logical work sequence for
machines which have to be completely adjusted. If only specifi c individual work steps are
carried out, both the preceding and following chapters must be observed.
Screws, nuts indicated in brackets ( ) are fastenings for machine parts, which must be
loosened before adjustment and tightened again afterwards.
13

Tools, gauges and other accessories for adjusting

.02
● Screwdrivers with blade width from 2 to 10 mm
● Spanners (wrenches) with jaw width from 7 to 14 mm
● 1 set Allen keys from 1.5 to 6 mm
● 1 clamp adjusting gauge Order No. 95-295 500-05
● Metal rule (part No. 08-880 218-00)
● Sewing thread and test materials
13

Abbreviations

.03
t.d.c. = top dead centre
b.d.c. = bottom dead centre
13

Explanation of the symbols

.04
In this adjustment manual, symbols emphasize operations to be carried out or important in-
formation. The symbols used have the following meaning:
56
Please observe all notes from Chapter 1 Safety of the instruction manual!
In particular care must be taken to see that all protective devices are refi tted
properly after adjustment, see Chapter 1.06 Danger warnings of the instruc-
tion manual!
If not otherwise stated, the machine must be disconnected from the electrical
power supply. Danger of injury due to unintentional starting of the machine!
Note, information
Service, repair, adjustment, maintenance
(work to be carried out by qualifi ed staff only)