KTM 690 enduro R EU Repair Manual page 101

15 BRAKE SYSTEM
–
Pull off protection cap
(standard workshop equipment).
–
Release bleeder screw
Info
During suction, ensure that the brake fluid reservoir is always filled with a
sufficient amount of fresh brake fluid.
–
Tighten the bleeder screw. Remove the suction device and mount the protection
cap.
301894-10
–
Add brake fluid to the MAX mark.
Brake fluid DOT 4 / DOT 5.1 (
–
Mount the screw cap with the washer and membrane.
–
Activate the foot brake lever until there is a firm pressure point.
Info
Clean up overflowed or spilt brake fluid immediately with water.
and connect a commercially available suction device
4
and draw out the old brake fluid.
5
p. 212)
99