Removing Timing Chain Rails; Removing Timing Chain And Timing Chain Sprocket; Removing Crankshaft Position Sensor - KTM 690 enduro R EU Repair Manual

17 ENGINE

17.3.20 Removing timing chain rails

17.3.21 Removing timing chain and timing chain sprocket

17.3.22 Removing crankshaft position sensor

–
Remove screws
–
Pull the timing chain guide rails
Info
The support bushing is plugged through the timing chain guide rails into the
timing chain securing guide.
–
Remove the timing chain guide rails upward out of the timing chain shaft.
300045-10
–
Hold the timing chain securing guide tight and pull the timing chain tensioning
rail out of the timing chain securing guide.
4
–
Remove the timing chain tensioning rail upward out of the timing chain shaft.
–
Remove the timing chain securing guide
300046-10
–
Slip out timing chain
Info
Mark the direction of travel.
–
Take off lock ring.
300148-10
–
Pull of the timing chain sprocket with the special tool
Extractor (59029033000) (
300149-10
–
Remove the screws of crankshaft position sensor
–
Pull cable support sleeve
tion sensor.
300151-10
.
1
out of the timing chain securing guide
2
3
.
1
p. 217)
out of the engine case. Take off the crankshaft posi-
2
.
.
2
.
1
118
.
3