Changing The Engine Oil And Filter, Cleaning The Oil Screens; Draining The Engine Oil - KTM 690 enduro R EU Repair Manual

20 LUBRICATION SYSTEM
20.4

Changing the engine oil and filter, cleaning the oil screens

20.5

Draining the engine oil

Warning
Danger of scalding Engine oil and gear oil get very hot when the motorcycle is ridden.
–
Wear appropriate protective clothing and safety gloves. In case of burns, rinse immediately with lukewarm water.
Warning
Environmental hazard Hazardous substances cause environmental damage.
–
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
Info
Drain the engine oil only when the engine is warm.
–
Change the oil filter. Check oil pumps for wear. Check all oil channels for
free flow.
–
Switch off the engine.
Warning
Danger of burns Some vehicle components get very hot when the machine
is driven.
–
–
Remove the special tools.
–
Mount and tighten screw
Guideline
Screw, unlocking of timing chain ten-
sioner
Finishing work
–
Check the engine oil level. (
–
Drain the engine oil. (
–
Remove the oil filter. (
–
Clean the oil screens. (
–
Install the oil filter. (
–
Fill up with engine oil. (
601022-10
Preparatory work
–
Remove the engine guard. (
Main work
–
Place a suitable container under the engine.
–
Remove the oil drain plug
–
Completely drain the engine oil.
100200-10
Wear appropriate protective clothing and safety gloves. In case of burns,
rinse immediately with lukewarm water.
.
1
p. 170)
p. 172)
p. 173)
p. 174)
p. 173)
p. 175)
p. 36)
with the magnet and seal ring.
1
M10x1 10 Nm (7.4 lbf ft)
172