Removing Piston; Removing Rotor - KTM 690 enduro R EU Repair Manual

17 ENGINE

17.3.18 Removing piston

17.3.19 Removing rotor

–
Take off the cylinder head gasket
–
Remove screw
–
Push the cylinder upward.
Info
Push the cylinder upward only far enough to allow removal of the piston pin.
Ensure that the two grooved pins remain in place.
300030-10
–
Remove piston pin retainer
–
Remove the piston pin.
–
Take off the cylinder with the piston.
–
Push the piston upward out of the cylinder.
Info
If no other work is required on the cylinder and the piston, you can leave the
piston in the cylinder.
–
300031-10 Take off the cylinder base gasket.
Info
Ensure that the two grooved pins remain in place.
–
Remove special tool
Engine blocking screw (77329010000) (
300044-10
–
Use the special tool to hold the rotor tight.
Holding spanner (75029091000) (
–
Loosen the nut
Info
The crankshaft must not be blocked.
300040-10
–
Install the special tool
off the rotor by turning the screw in.
Extractor (58429009000) (
–
Remove the special tool.
302120-10
.
1
.
2
.
3
.
1
p. 223)
of the rotor and remove it with the tab washer.
1
on the rotor. Hold it tight using the special tool and pull
2
p. 216)
p. 223)
117