KTM 690 enduro R EU Repair Manual page 109

17 ENGINE
–
Take off the engine sprocket.
–
Take off the clutch slave cylinder and hang it to the side.
Info
Do not bend the clutch line.
Do not activate the clutch lever if the clutch slave cylinder has been
removed.
–
Take off the clutch push rod.
–
Unscrew the electrical connection
–
Remove ground wire
300216-10
–
Loosen hose clip
–
Pull off the throttle valve body from the rear.
300217-10
–
Disconnect connector
and the alternator.
–
Remove the cable binders and release the cables.
300218-10
–
Pull of the spark plug connector.
–
Unplug the connector of the engine coolant temperature sensor
300188-10
–
Loosen the spring-loaded band-type clamp
line with the special tool.
Pliers for spring band clamp (60029057100) (
300220-10
from the starter motor.
7
from the starter motor.
8
.
9
of the gear position sensor, the crankshaft position sensor,
bk
bm
.
bl
from the breather, SLS and oil return
p. 218)
107