Starting Output; Getting Ready To Receive Data From A Computer - Roland XC-540 User Manual

2-4 Starting Output

Getting Ready to Receive Data from a Computer

When you have finished loading media and making the temperature settings for the heating devices, then follow the
steps below. This procedure enables the machine to receive data from the computer and perform output.
Note, however, that when you want to perform only cutting, operation that differs from the following procedure is
required.
P. 46, "To Perform Cutting"
Procedure
–
Close the front cover.
—
Press (making the light come on).
˜
Wait until
™
Make sure you are at the top menu.
If you are not at the top menu, press
Output Is Not Possible in These Situations
➢The machine does not run when the front cover is open. Also, never open it when output is in progress. Doing so
interrupts output.
➢ Data from the computer is not accepted when
➢ Printing does not start until
➢ Data from the computer is not accepted when you are not at the top menu.
Points Which Must Be Observed
➢ Be sure to set the media clamps during printing. Otherwise the edges of the media may warp and catch on the print
heads.
➢ During output, never touch the media that's already been discharged. Doing so may obstruct media feed or cause
the media to rub against the heads, which may result in a paper jam or damage to the heads.
stops flashing and stays steadily lit.
, then press
W 1371 mm
lights up.
.
Top screen
Steadily lighted
Steadily lighted
is dark.
SET UP
Flashing
HEATER CONFIG
Chapter 2 Operation 39