The Take-Up System; Features Of The Take-Up System; Operating Conditions For The Take-Up System - Roland XC-540 User Manual

4-1 The Take-up System

Features of the Take-up System

Using the take-up unit lets you perform printing while the media is taken up automatically. This makes possible
unattended operation at night and efficient output of lengthy media.

Operating Conditions for the Take-up System

Never Use When Performing Cutting
Never use the take-up unit when you're performing cutting operations. Use is possible only when performing
printing.
Settings Related to Media Feed
When using the take-up unit, avoid media take-up operations using
undue force, such as unsuitable take-up by the take-up unit, can cause printing to stop or result in misalignment of
the printing position.
When you're using the take-up system, be sure to make settings as described below.
➢When loading and setting up media, set the [SETUP SHEET] menu item to "TU."
➢When feeding out media toward the front of the machine by pressing
➢Set the [PREFEED] setting-menu item to "DISABLE."
Important Notes About Automatic Media-cutoff Functions
Never cut off the media while take-up is in progress. Take-up quits as soon as the media is cut off. Be especially
careful when you're printing more than one page.
The setting for turning off automatic cutoff is made on the computer.
Margin Settings
If you can set the margins on the computer, set them each to 40 millimeters or more.
56 Chapter 4 Operation of the Media Take-up System
. Operations that pull the media with
, be sure to set the base point.