Roland XC-540 User Manual page 107

3.
Print a test pattern and cut it.
–
MENU
CUTTING MENU
—
CUTTING MENU
PRINT - CUT ADJ.
˜
PRINT - CUT ADJ.
TEST PRINT
Cutting position and print-
ing position are misaligned.
When adjustment is needed, go on to the steps below.
4.
Print a test pattern and cut it.
PRINT - CUT ADJ.
TEST PRINT 2
5.
From the test pattern, read the value at the location.
Test pattern
Correction-value scale
+2.0 +1.5
-2.0 -1.5
Check the value on
the [FEED] side.
Press
Press
Press
Press
Press
Cutting position
Printing position
Press
Press
+2.0 -2.0
+1.5 -1.5
-1.0
+0.5 -0.5
+0.0 -0.0
SCAN
+1.0 +0.5 +0.0
FEED
-1.0 -0.5 -0.0
6-7 Correcting Misalignment for Printing or Cutting
.
.
.
.
.
Cutting position and print-
ing position are aligned.
.
to execute.
Check the value on
the [SCAN] side.
Scan direction
Cutting line
Cutting position
Printing position
Cutting line
-0.5
The point where the cutting line
intersects the correction-value
scale is the correction value. In this
figure, the value is "-0.3." Use the
same method to read the value on
the [FEED] side.
Chapter 6 Feature Reference 105