Starting Output - Roland VersaUV LEJ-640 F User Manual

Starting Output

Creating Output Data
Create the output data using the application software like Adobe Illustrator and like that. For information on
how to create the data, refer to the documentation of your application software.
Sending the Output Data to This Machine Using the Software RIP.
Use the included software RIP "Roland VersaWorks." For information on how to install and use Roland Versa-
Works, refer to "Roland VersaWorks Quick Start Guide" and HELP of Roland VersaWorks. If using the white ink
and gloss ink, refer to "White & Gloss Ink Guide."
Use the media clamps when using media that is less than 0.5 mm (0.02 inches) thick. Otherwise
the edges of the media may warp and catch on the print head.
If you are using media that is less than 0.5 mm (0.02 inches) thick, do not use the media clamps if
[HEAD HEIGHT] is set to [LOW]. The media clamps may catch on the print heads, damaging the
machine.
P. 78, "Adjusting Head Height to Match Media Thickness"
During output, never touch the media. Doing so may obstruct media feed or cause the media to
rub against the heads, which may result in a paper jam or damage to the heads.
Keep the loading lever raised when the machine is not in use.
If Ink Runs Out
When ink runs out, a warning beep sounds and a slot number of which ink runs out is displayed on
the display screen.
Before you perform lengthy printing, check the amount of ink remaining in the ink car-
tridges.
Before you perform lengthy printing, check the amount of ink remaining in the ink cartridges. When
ink runs out and printing is paused, the coloring at the seam may be altered when printing resumes.
Points that must be observed
Outputting
2
41