Preventing Pulling Of The Media With Undue Force When Performing Cutting Only; Drying The Trailing Edge Of The Printing Area On The Dryer - Roland XC-540 User Manual

Preventing Pulling of the Media with Undue Force When Performing Cutting Only

Procedure
–
MENU
CUTTING MENU
—
CUTTING MENU
PREFEED
˜
PREFEED
DISABLE ENABLE
™
W 1346mm
SETUP SHEET
ROLL
Description
When you're performing cutting only, it may be convenient to set this feature to "ENABLE." This feeds out media
according to the size of the data sent from the computer before performing cutting. This makes it unnecessary to turn
the media flanges by hand to feed out media every time you perform cutting. Note, however, that this feeds out media
even when you're performing printing only, so set it to "DISABLE" when not needed.
Default Setting
[PREFEED]: DISABLE

Drying the Trailing Edge of the Printing Area on the Dryer

Procedure
–
HEATER MENU
FEED FOR DRY
—
FEED FOR DRY
DISABLE
ENABLE
˜
W 1346mm
SETUP SHEET
ROLL
Description
When this menu item is set to "ENABLE," additional media feed is performed until the trailing edge of the printing area
is positioned directly on the dryer. The margin between the print-end position and the next print-start position is fixed
at 200 mm. Any margin setting made on the computer is ignored.
When this is set to "DISABLE," media feed stops simultaneously when printing ends. This means that the trailing edge
of the printing area is not fed to the dryer unless you continue with a subsequent printing operation.
Default Setting
[FEED FOR DRY]: DISABLE
Press .
Press .
Press .
Press several times.
Press .
Use to select "DISABLE."
Press to enable the setting.
Press .
Press to go back to the original screen.
Hold down and press
Press .
Use to select "ENABLE."
Press to enable the setting.
Press .
Press to go back to the original screen.
6-5 Setting How the Printer Operates
.
Chapter 6 Feature Reference 93