Table of Contents
Advertisement
4. Remove the processor housing assembly from the server:
28
xSeries 370 Installation Guide
a. Open the two latches 1 at the top of the processor housing assembly
2 . Fully extend the latches.
b. Pull the processor housing assembly partially out of the server,
approximately 203.2 mm (8 in.).
Attention: To avoid injury, do not place your fingers immediately behind
the latches at the top of the processor housing assembly.
c. Close the latches at the top of the processor housing assembly.
Attention: Do not lift the processor housing assembly by the latches.
d. Grasp the bottom sides of the processor housing assembly. Lift and slide
the assembly out of the server until it stops, approximately 228.6 mm (9
in.); then, lift the assembly slightly and remove it from the server.
Note: If the assembly stops before you can slide it out of the server, lift it
slightly and continue to remove it from the server.
e. Place the processor housing assembly on a flat, static-protective surface,
with processor labels A1–A4 and B1–B4 right side up.
Advertisement
Table of Contents
