Table of Contents
Advertisement
c. Make sure that the retaining clips 2 are in the closed position.
d. Repeat these steps for each DIMM that you install.
9. Reinstall the memory board:
a. Insert the memory board into the guides and gently press the memory
board into the connector. When you install the memory board in the
server, be sure that it is correctly seated in the connector before you apply
force to close the latches.
b. Push the latches 1 until they close and lock in place.
Attention: To ensure proper EMC containment and cooling for your server,
reinstall the memory-access panel before turning on the server.
10. Reinstall the memory-access panel:
a. Ensure that the memory-access panel is fully seated in the appropriate
location.
b. Press in the two plastic fasteners on the memory-access panel to secure it
into place.
11. Reinstall the front bezel.
12. If you have other options to install, do so now. Otherwise, go to "Completing
the installation" on page 35.
Chapter 2. Installing options
23
Advertisement
Table of Contents
