IBM eServer 370 xSeries Installation Manual page 34

5. If you are not installing an optional memory board, continue with step 6 on
6. Remove the memory board from the server:
7. Touch the static-protective package containing the DIMM to any unpainted
8. Install the DIMM:
22
xSeries 370 Installation Guide
page 22.
If you are installing an optional memory board, touch the static-protective
package containing the memory board to any unpainted metal surface on the
server. Then, remove the memory board from the package. Continue with
step 7.
a. Pull both latches 1 simultaneously so that they fully extend from the
memory board.
b. Grasp the two latches and pull the memory board from the server.
c. Place the memory board connector-side up on a flat, static-protective
surface.
metal surface on the server. Then, remove the DIMM from the package.
Attention: To avoid breaking the retaining clips or damaging the DIMM
connectors, handle the clips gently.
1
Latches
2
Retaining clips
3
DIMM
Note: Install the DIMMs in the order indicated on the system label on the
server cover (see note 3 on page 19).
a. Turn the DIMM 3 so that the keys align correctly with the connector.
b. Align the keyed DIMM 3 , and press on both sides of the DIMM as you
insert it into the connector. Be sure to press the DIMM straight into the
connector.
Note: If a gap exists between the DIMM and the retaining clips, the DIMM
has not been properly installed. Open the retaining clips and
remove the DIMM; then, reinsert the DIMM.