Table of Contents
Advertisement
(Refer to the layout of the processor controller card in the User's Reference on
the IBM xSeries Documentation CD for the location of the cache coherency
filter card A and the cache coherency filter card B connectors.)
7. Your server comes with a processor installed in connector A1, on the standard
processor daughterboard (A). If you need to install additional processors,
install them in the following order:
A1, A3, A2, A4
If you need to install processors on the optional processor daughterboard (B),
install them in the following order:
B1, B3, B2, B4
To install a processor:
1. Review the information in "Safety" on page v through "Handling static-sensitive
devices" on page x.
2. Run the shutdown procedure for the operating system. Turn off the server and
peripheral devices, and disconnect all external cables and power cords; then,
remove the front bezel.
3. Remove the three processor fans:
a. Pull the fastener 1 in the top center of the fan housing 2 . This places
the fastener in the unlocked position.
b. Pivot the fan downward and remove it from the server.
c. Repeat steps 3a and 3b for each additional fan.
Chapter 2. Installing options
27
Advertisement
Table of Contents
