Table of Contents
Advertisement
18
xSeries 370 Installation Guide
c. Align the holes in the bottom of the jumper with the center pin and the pin
that was not covered previously.
d. Slide the jumper fully onto these pins.
e. Reinstall the I/O function card:
1) Refer to the illustration in step 3a1 on page 17 while you perform the
steps in this procedure.
2) Carefully grasp the I/O function card by its top edge, and insert the tabs
on the bottom edge of the metal connector plate into the matching
openings on the server back panel.
3) Align the I/O function card with the guide on the opposite end of the
adapter and the slot on the I/O board.
4) Press the I/O function card firmly into the slot.
Attention: When you install the I/O function card in the server, be
sure that it is completely and correctly seated. Incomplete insertion
might cause damage to server components.
5) Reinstall the I/O function card retention bracket that you removed in
step 3a4 on page 17 by pressing in the fastener on the bracket.
6) Insert the two screws that you removed in step 3a3 on page 17.
7) Connect the cables that you disconnected in step 3a2 on page 17.
Refer to the illustration of the I/O function card in the system label on
the server cover for the connector locations on the I/O function card.
f. The SCSI cable comes with two standard folds. Unfold the SCSI cable at
the fold that is closer to the connector on the end of the cable. If
necessary, refer to the illustration at the beginning of this procedure.
g. Install the ServeRAID adapter in PCI slot 10, 11, or 12.
h. Connect the internal SCSI port B end of the SCSI cable to the appropriate
channel on the ServeRAID adapter 3 . Refer to your ServeRAID adapter
option documentation for more information about installing the adapter and
configuring a disk array.
i. If you have other options to install or remove, do so now; otherwise,
continue with "Completing the installation" on page 35.
Advertisement
Table of Contents
