Table of Contents
Advertisement
Table 5 shows the memory installation requirements for your server.
Table 6 shows the available memory configurations.
20
xSeries 370 Installation Guide
Table 5. Memory installation requirements
DIMM sizes
DIMM population order for a single board
configuration — standard memory board (A)
DIMM population order for a dual board
configuration — standard memory board (A)
and optional memory board (B)
Notes:
1. The 100 MHz DIMMs support the registered mode of operation.
2. Install DIMMs with a maximum height of 4.32 cm (1.7 inches).
3. Your server comes with one standard (preinstalled) memory board (A), and one or more DIMMs
installed on this memory board. You can install an optional memory board (B). Both the
standard memory board (A) and the optional memory board (B) contain 16 DIMM connectors
(J1–J16).
4. When you install DIMMs in both the standard memory board (A) and the optional memory board
(B), you must install them in matching pairs with the same part number, in the same slot on
each memory board; for example, J1/J1, J5/J5, J9/J9, and so on.
Table 6. Memory expansion
DIMM size
128 MB
256 MB
512 MB
1 GB
128 MB, 256 MB, 512 MB, 1 GB
A1, A5, A9, A13, A3, A7, A11, A15, A2, A6,
A10, A14, A4, A8, A12, A16
A1/B1, A5/B5, A9/B9, A13/B13, A3/B3, A7/B7,
A11/B11, A15/B15, A2/B2, A6/B6, A10/B10,
A14/B14, A4/B4, A8/B8, A12/B12, A16/B16
16 Connectors
(1 Board)
2 GB
4 GB
8 GB
16 GB
32 Connectors
(2 Boards)
4 GB
8 GB
16 GB
32 GB
Advertisement
Table of Contents
