Reception Failures - Minolta Di200f Operator's Manual

10-48
13. Facsimile is not Functioning Properly

Reception Failures

Symptom
The received image is
unclear.
A blank sheet is printed on
the reception paper.
Automatic reception is not
possible.
Black lines are evident on
the received paper.
Possible Cause
Is the recommended paper being
used?
Is the paper damp?
Is the amount of toner sufficient?
Is the Toner Bottle placed in
position?
Is there a program with the line
condition or the fax machine at the
destination?
Is the amount of toner sufficient?
Has the sender placed the document
reverse way between the front and
back side?
Is manual reception set?
Is memory full?
Is a report being printed?
Is a message being shown?
Is there a program with the line
condition or the fax machine at the
destination?
Action
Use recommended paper.☞p.11-2
Change paper with one fresh from
its package.☞p.10-2
Change the Toner Bottle.
☞p.10-10
Reposition the Toner Bottle.
☞p.10-10
Use this machine to make a copy
for check. If a good, clear copy is
produced, try sending it again.
Change the Toner Bottle.
☞p.10-10
Check the sender.
Select automatic reception.
☞p.9-26
If paper has run out, add paper and
print documents stored in memory.
☞p.10-2
Wait until printing of the report is
complete.
Follow the instructions to reset the
alarm. ☞p.10-42
Use this machine to make a copy
for check. If no black lines occur on
the copy, ask the sender to re-send.