The Machine Is Not Functioning As Designed - Minolta Di200f Operator's Manual

10-46

12. The Machine is not Functioning as Designed

The machine is not functioning as designed
Symptom
The Touch Panel shows
nothing.
The Start key does not light
green.
No copies are fed out when
the Start key is pressed.
Control panel keys do not
respond.
The machine is not activated
when the Power Switch is
turned ON.
* If these procedures do not correct the problem, turn OFF the Power Switch, unplug the power cord from
the power outlet, and contact your Technical Representative.
Possible Cause
Is only the Start key lit green?
Is the Power Switch turned ON?
The Display Contrast Knob is
turned to the excessively light or
dark position.
Is your Access Code or Access
Number entered?
4016P492CA
The machine has developed a
malfunction.
The machine has just been turned
ON and is warming up.
The Interrupt key LED is lit.
1166O260AA
The power cord is left unplugged.
The room circuit breaker is open.
Action
The machine is in the Energy Save
Mode, LCD Back-light Off, or
Sleep mode.
Press any key on the control panel
to let the machine exit the mode.
Turn the Power Switch ON.
Viewing the Touch Panel, adjust the
Display Contrast Knob as
necessary.
Enter your Access Code or Access
Number by following the procedure
given in "Entering the Access
Code/Access Number." ☞p.2-35
Check the Touch Panel and take
action according to the message on
the panel.
It takes the machine about 60 to 70
seconds to be ready to make copies
after it has been turned ON. Please
wait.
The machine is in the interrupt
mode. Press the Interrupt key to
cancel the interrupt mode.
Plug the power cord into the power
outlet.
Close the room circuit breaker.