Facsimile Is Not Functioning Properly; Transmission Failures - Minolta Di200f Operator's Manual

13. Facsimile is not Functioning Properly

Transmission Failures

Symptom
The document is not
scanned.
The document is not
scanned slantways.
The image received at the
destination is not clear.
A blank sheet is printed at
the destination.
Automatic transmission is
not possible.
TX Marker is too faint
(option).
Possible Cause
Is the document too heavy?
Is the document too thin or too
small?
Is the Original Glass dirty?
Are the Document Guide Plates
pressed tightly up against the edges
of the document?
Is the document placed in position? Position the document
Is the Original Glass dirty?
Is the text on the document too
faint?
Is there a program with the line
condition or the fax machine at the
destination?
Is the document loaded face down
(if the document feeder is being
used)?
Is the number wrong?
Are you calling a number dedicated
to telephone use?
Is there a problem at the destination
(such as paper out, set to disable
automatic reception, and power
OFF)?
Has the life of the Marker Stamp
been reached?
Action
Send the document by placing it on
the Original Glass.☞p.2-30
Send the document by placing it on
the Original Glass.☞p.2-30
Wipe the surface of the Original
Glass clean with a dry soft
cloth.☞p.11-10
Slide the Document Guide Plates to
the exact size of the document.
☞p.2-27
correctly.☞p.2-27
Wipe the surface of the Original
Glass clean with a dry soft cloth.
☞p.11-10
Adjust contrast for scanning.
☞p.5-10
Use this machine to make a copy
for check. If a good, clear copy is
produced, try sending it again.
Load the document face up and try
sending it again.☞p.2-27
Reconfirm the number.
Reconfirm the number.
Contact the destination.
Replace the Spare TX Marker
STAMP. ☞p.10-40
10-47