When Using The Ieee 1394 Cable With Windows Me - Minolta DiMAGE Scan Elite II Instruction Manual

When using the IEEE 1394 cable with Windows Me

1
Quit the utility software.
2
Confirm the DiMAGE Scan Elite II indicator lamp is on and not
blinking.
• If other USB or IEEE devices are connected to the computer, confirm that they are not in
operation before continuing.
3
Double-click on the "Unplug or Eject Hardware"
icon on the task bar.
• The unplug-or-eject-hardware dialog box will appear.
4
Select "Minolta DiMAGE Scan Elite 2" and
click [Stop].
• A confirmation screen will appear.
5
On the confirmation screen, confirm the
device to be stopped. Click [OK] to stop
the device.
6
The "Safe to remove hardware"
message will confirm the operation.
Click [OK] to finish.
7
Disconnect the cable.
• If the scanner is disconnected or turned off without
following the above procedure, a message will appear to
indicate that the unsafe removal of device may cause
your computer to crash and lose valuable data. Click
[OK] and then check the image data.
87