Table of Contents
Advertisement
About Entering Commands on the Command Line
Supported Devices
About This Guide
Other Documents in the Library
10
Step F: Configure Other Features as Required
See the following for information on setting up other features:
•
"Configuring PPP" on page 31
•
"Configuring Autoconnection" on page 49
•
"Configuring IP Routing" on page 53
•
"Configuring Security Features" on page 57
•
"Configuring DNS" on page 65
If you use the command line, you will find the commands needed within
each chapter. For detail such as syntax, parameters, range, variables, or
applications see the Digi One/PortServer TS 2/4 Command Reference
found on the Software and Documentation CD.
This manual provides information on the following Digi devices:
•
Digi One RealPort Wireless
•
Digi One TS Wireless
•
PortServer TS 2 MEI Wireless
•
PortServer TS 4 MEI Wireless
Purpose
This guide provides the following:
•
Configuration and administration procedures
•
Configuration examples
Audience
This manual is intended for the person responsible for configuring and
administering device server. It assumes that this person has experience
configuring network devices and is familiar with networking concepts.
Scope
This manual provides step-by-step instructions for configuring and
administering device server's main features. It does not address how to
configure every option, provide complete information on commands, or
discuss hardware installation. These topics are covered in other
documents in the device server library.
Here is a list of the other documents in the library:
Device Server Quick Start Guide
The guide that comes in the package with the device server covering the
first steps necessary to get your device server up and running.
Chapter 3 Introduction
Advertisement
Table of Contents
