Serial Power Table
Chapter 18 Configuring Power Over the Serial Ports
instructions to reset.
From the command line use the two examples below for additional
information.
display circuitbreaker
Display the status of the circuit breaker
set configuration circuitbreaker=reset
Reset the circuit breaker
Note:
set configuration print will also give the status of the circuitbreaker state.
Use this table for summary information for a serial power setup.
.
Quick Summary
Table for Setup of
Serial Power
Switch Settings
DTR setting
Ports Allowed
Jumper Pin Settings
Power Budget
DTR Power
OUT
DTR ON
1, 2, 3, 4
*unless port 1 is used
P-6 jumper on pins
P-6 jumper on pins
2 & 3
(Factory Default)
(Factory Default)
9v @ up to 100mA
5v @ up to 200 mA
one watt
RI Power
OUT
DTR OFF
DTR OFF
1*, 2, 3, 4
for power in
P-6 jumper on pins
2 & 3
9 -30 v @ up to
one watt
525mA (max)
IN
1
1 & 2
77