Configuring Proxy ARP
Chapter 11 Configuring IP Routing
187.100.46.9
set forwarding state=active poisonreverse=on splithorizon=on
set user name=link1...netrouting=off
This section describes how to configure device server for Proxy ARP.
Related Information
See the set forwarding command in the Digi One/PortServer TS Command
Reference.
Starting Point
This procedure assumes that you have signed on as root and have or will
configure modems, modem scripts, devices, and filters for routes that use
serial lines.
Procedure
1. Configure the links over which packets will be routed using a set user
command. This command must specify (on the ipaddr field) a specific
IP address for the remote system using the Proxy ARP service.
2. Configure device server for Proxy ARP by supplying a set forwarding
command that specifies the following:
•
state=passive
•
proxyarp=on
Example
In this example, device server provides Proxy ARP services to a remote
host.
187.155.24.0
set user name=link1...ipaddr=187.155.24.11
set forwarding state=passive proxyarp=on
192.150.75.0
Router
Digi Device
PPP
Digi Device
PPP
187.155.24.11
55