Configuring The Serial Port Settings From The Command Line - Digi TS W User Manual

Configuring the Serial Port Settings from the Command Line

26
5. Click Change Profile and select a profile based on the device you have
connected to your port. Custom will expose all settings.
6. Click Apply to save the profile. The interface will determine any
additional settings and advise you what tab to click next.
7. A port profile or port options page will come up and ask for additional
parameters if needed. Enter the appropriate parameters and click
Apply.
Use the set ports, set line, and set flow commands from the Digi One/
PortServer TS 2/4 Command Reference to set the serial port settings.
Chapter 7 Configuring the Serial Ports