Bernina bernette 0 Instruction Manual page 76

10 12
EN Sewing on buttons
Install the darning plate. (1)
Change presser foot to button sewing foot.
Turn the stitch length dial to "0".
Position the work under the foot. Place the
button on the marked position and lower the
foot. Set the pattern selector knob on " "
or " " and sew a few securing stitches.
Select the zigzag stitch width according to
the distance between the two holes of the
button. Turn the handwheel to check if the
needle goes into the right and the left hole of
the button without any obstruction (adjust the
stitch width according to the button). Slowly
sew on the button with about 10 stithces.
Select pattern " " and sew a few securing
stitches.
If a shank is required, place a darning needle
on top of the button and sew. (3) For buttons
with 4 holes, sew through the front two holes
first (2), push work forward and then sew
through the back two holes as described. (3)
Please note:
No "S" marking is shown on the stitch length
dial by model 10.