Bernina bernette 0 Instruction Manual page 38

10 12 15
EN Threading the upper thread
Caution:
- Turn power switch to "O" before threading
or unthreading the machine.
- To release the upper thread tension the
presser foot lever has to be raised.
- The thread take-up lever must be in the
highest position when threading.
1. Place spool on pin using appropriate
spool disc (spool turns clockwise). Take
thread through rear guide (A) and then
into slit of upper thread tension.
* Note:
If using special thread which winds quickly
off the spool attach a net to the spool before
using and use the larger spool holder.
Eventually reduce the thread tension as well.
2. Pull thread down to the right of the cover
around point (B).
3. Take thread up to the left of the cover,
placing it in the take-up lever (C).
4. Take thread down and through guide (D).
Insert the thread through the eye of the
needle from front to back.
5. Leave about 10 cm (4") of thread loose
behind the needle, or cut the excess
thread by using the thread cutter (E).