Expansion Kit - IBM Netfinity 6000R User Reference Manual

The following illustration shows the rear connectors on the SCSI repeater card, as
viewed from the rear of the server.
SCSI repeater
card cable
connector
The following illustration shows how to install a Netfinity 3-Pack Ultra160 Hot-Swap

Expansion Kit.

To install a Netfinity 3-Pack Ultra160 Hot-Swap Expansion Kit:
Attention: When you handle Electrostatic Discharge-Sensitive devices (ESD), take
precautions to avoid damage from static electricity. For details on handling these
devices, refer to the following Web site and search for ESD: http://www.ibm.com
98
IBM® Netfinity® 6000R User's Reference
1. Review the information in "Before you begin" on page 71 and in "Safety
information statements" on page 72.
2. Turn off the server and peripheral devices and disconnect all power cords and
external cables; then, remove the top cover (see "Removing the server top cover
and bezel" on page 77).
3. Refer to the documentation that comes with the option to assemble the hot-swap
expansion option.
4. Align the hot-swap expansion option with the empty slot at the rear of the
optional hard disk drive cage, adjacent to the standard hot-swap hard disk drive
backplane.
5. Slide the hot-swap expansion option down into the guides on the slot at the rear
of the optional hard disk drive cage, and secure it to the server with the blue slide
latch located on top of the optional hard disk drive cage.
6. Refer to the documentation that comes with the option to complete the
installation of the option.
SCSI power
cable
connector
2
I C cable
connector
SCSI cable
connector
Expansion backplane