Installing A Hot-Swap Power Supply - IBM Netfinity 6000R User Reference Manual

Installing a hot-swap power supply

94
IBM® Netfinity® 6000R User's Reference
To change a jumper position for a three-pin jumper block:
1. Turn off the server; then, disconnect all power cords and external cables.
2. Remove the server cover (see "Removing the server top cover and bezel" on page
77).
3. Lift the jumper straight off the pin block.
4. Align the holes in the bottom of the jumper with the center pin and the pin that
was not covered previously.
5. Slide the jumper fully onto these pins.
6. Reinstall the server cover and connect the cables (see "Installing the server top
cover and bezel" on page 101).
The following illustration shows how to install a hot-swap power supply.
Note: The illustrations in this document might differ slightly from your hardware.
3 2 1